PlayStation Logo 3D Model Another Update

Have another update on the PlayStation Logo model over at Printables.com  > here I have been working one.  All the parts are printed and painted.  However when I was sanding down the stand, broke off one of the pegs.  Glued that back on.  Going to let that set for a day before gluing on the other parts on to it.  Want to see if it holds up all right.  If not will have to print another stand.

PlayStation Logo 3D Model Update

A few posts back talked about the PlayStation Logo model over at Printables.com  > here.  Well have three of the four parts printed.  There is every little filament left on the spool so will have to wait to print the stand.  Don’t want to waste the filament.  So will print some small stuff with that before putting on a new spool.  In the mean time sanded the edges off the other parts.  Then took them out side to prime.  Think I am going to paint it a metallic blue and leave the stand black.  When it’s done will take a picture.

PlayStation Logo – 3D Model

Have seen a bunch of PlayStation related 3D models over at Printables.com.   A few days ago seen this one > here.  It is broken up into four parts.  Thought it’s cool, so will give it a try.   When I loaded it in the software it was a bit small.  Upscaled it to 200%.   The biggest part would take around five hours.  Started with that one.  It was getting close to printing the top layers and then the power went out.  So know I have to start over again.  Will be back with some updates.