Elegoo Neptune 2 Assembled

ELEGOO_Neptune_2.jpgWell today (June 27, 2021) I got my Elegoo Neptune 2 FDM 3D Printer assembled.  Took me a few hours.  Not because it was over complicated.  It was just the paper instructions were good but not helpful for me in spots.  Luckily there is an instructional video on the SD card.  That help out a lot.  Noticed that the print bed moved a bit.  There is a spot in the video that shows how to fix that.  However there is another problem that is not in the manual or video.  The printer doesn’t sit very level.  Seen on a Neptune Facebook page how to fix that.  There are four screws on the legs you loosen.  This will help it lay flat, then you tighten then back up.  My next step is to plug in the wires, level the bed and do a test print.  Will be back with another update. 

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

This site uses Akismet to reduce spam. Learn how your comment data is processed.

%d bloggers like this: